HOTWATER – Monoblock 80/100/150 litres – R290 – DUCTED Kitchen series

TWMMS 09080 J - TWMMS 09100 J- TWMMS 09150 J

Typology

Indoor unit, Monoblock
Solution

Domestic hot water
Applications

Office, Store, Whole house
Heating system

Heat pump water heater

Share this product:

HOT WATER 80/100/150 LITRES AT R290 DUCTED KITCHEN SERIES

MONOBLOCK HEAT PUMP WATER HEATER, DESIGNED TO BE INSTALLED INSIDE THE TALL CABINETRY OF THE KITCHEN

  • R290 refrigerant gas

  • Titanium anode

  • Energy Efficiency Class A+

  • Hot water up to 65° C with compressor only

  • Anti-Legionella cycle

  • Exceptional resistance to corrosion thanks to the titanium anode included as standard

Features

A+

Energy class

R290

Refrigerant gas

< 65°C

Temperature with only the compressor

80/100/150 L

Maximum tank capacity

Comfort at home

Designed to be installed in the kitchen, just like a traditional boiler, the ”Ducted Kitchen” series is conveniently placed inside the tall cabinetry of the kitchen, with air extraction to the outside.

Safety

  • The tank is protected from corrosion by the titanium anode included as standard.

  • Anti-legionella system: the danger of legionella bacteria is averted thanks to periodic cycles that raise the temperature of the water inside the storage tank above 65°C.

Installation warnings

  • It is mandatory to install a safety and non-return valve on the cold-water inlet. Failure to do so could seriously damage the equipment. Use a valve with a 0.7 MPa setting.
    For the installation location, please refer to the piping connection diagram.

  • The discharge pipe of the safety valve must descend vertically and must not be placed in an environment where there is a risk of freezing.

  • The water must be able to drip freely from the pipe and its end must be left free.

  • The safety valve must be tested regularly to check its function and to remove any limescale that might block it.

Download